Naim-audio NAP 500 User Manual download pdf (Page 28)

E26

NAIT 5i Integrated Amplifier

25 NAIT 5i Introduction and Installation

The Nait 5i should be installed on a dedicated equipment stand intended for the

purpose. Do not stand it directly on top of another item of equipment. Care should

be taken to ensure that it is level. The amplifier should be installed in its final location

before connecting cables or switching on. Ensure that the volume is turned down before

switching on.

The following Section 25 paragraphs describe installation features and functions specific

to the Nait 5i. Operational features common to all preamplifiers and integrated amplifiers

are described in Section 28.

25.1 Inputs

The front panel input selector buttons select the source

input signal to be routed to the power amplifier and the

loudspeakers. The four buttons are labelled cd, tuner, hdd

and av. Each input button corresponds to a pair of rear

panel RCA Phono input sockets. The cd and tuner inputs

are additionally provided with alternative DIN sockets.

These should be used in preference to the RCA Phono

sockets if practical. Do not connect both the DIN and

RCA Phono sockets of one input simultaneously.

A 3.5mm stereo Jack input socket suitable for an iPod* (or

alternative portable music player) on is also provided on

the Nait 5i front panel.

Insertion of a plug into the front panel socket will

automatically switch the preamplifier to that input.

Removal of the plug will return the amplifier to the

previously selected input.

Note: The mute function will not operate when the front

panl input is in use.

25.2 Outputs

A stereo set of speaker connection sockets is provided

on the rear panel. The sockets can accept standard

4mm plugs, but to comply with European legislation the

Naim connectors supplied should be used. Naim Audio

speaker cable will provide the best results; however, a wide

range of speaker cable types can be used without risk of

damage to the amplifier.

Ensure when connecting speakers that they are “in

phase”. That is, the positive and negative connection

orientation at both the speaker and amplifier ends of the

cable is the same for both channels.

The hdd output always carries the selected input signal.

volume

source selection

26 NAIT 5i Controls and Connections

26.1 NAIT 5i Front

Operational features

common to all

preamplifiers and

integrated amplifiers

are described in

Section 28

front panel

input socket

1 2 ... 23 24 25 26 27 28 29 30 31 32 33 ... 43 44

Comments to this Manuals

No comments

Naim-audio NAP 500 User Manual Page 28

Comments to this Manuals

Related products and manuals for Receivers and Amplifiers Naim-audio NAP 500